GPIO Hammer Header (Solderless) Male + Female + Installation Jig Reviews

4.8 Rating 120 Reviews

Visit Product Page

Email:

contact@thepihut.com

Location:

Mann Enterprises LTDHomefield RoadHaverhill, SuffolkCB9 8QP
Cambridge
CB9 8QP

Visit Product Page

“Does the job it's supposed to do.”

Helpful Report

Posted 8 years ago

“Great!”

Helpful Report

Posted 8 years ago

“I was able to put a header on my raspberry pi zero w and on my phat dac. I almost attached the male header at an angle, so be careful during assembly.”

Helpful Report

Posted 8 years ago

Guarnaccia D

Verified Reviewer

“Amazing, very useful!!!”

Helpful Report

Posted 8 years ago

“Easy to use and delivers as promised”

Helpful Report

Posted 8 years ago

“The kit is easy to use, even though you have to hammer a bit harder than you expect. Used it both for the female and male headers (had two pi zero's at hand). The screws could be a bit less tight to make it easier to slide the plastic mounts. I had some trouble uncoupling the pi from the mount after hammering, it got stuck to the bottom layers. Had to unscrew the screws all the way out so that i could yank it a bit. The female header is the easyer to mount. Unfortunately after mounting the male header the little plastic support that you hammer on broke in halve. Fortunately I was finishing the second header and was able to complete the process. If the part was a bit thicker i believe it would last longer. Overall its a great tool for helping to mount the solderless headers.”

Helpful Report

Posted 8 years ago

“Very Easy!! Perfect”

Helpful Report

Posted 8 years ago

“I was about to buy a soldering iron when I got my Raspberry Pi Zero W. Then I discovered this GPIO Hammer Header. It was really easy to install following the guide and with the installation jig. Even if I have used a soldering iron in the past, this was much faster for me. I really recommend it.”

Helpful Report

Posted 8 years ago