Aluminium Raspberry Pi 4 Case Black Reviews

4.3 Rating 63 Reviews

Visit Product Page

Email:

contact@thepihut.com

Location:

Mann Enterprises LTDHomefield RoadHaverhill, SuffolkCB9 8QP
Cambridge
CB9 8QP

Visit Product Page

“Nice compact case, smart too. Everything fits well and there’s enough internal clearance to fit heat sinks and a small fan. It’s a decent basic case with room to develop.”

Helpful Report

Posted 1 year ago

“This is my second of these cases - a lovely, professional looking and sturdy aluminium case for keeping the Pi cool and safe. My first case has been used with my astronomy kit for almost 2 years - so has had a lot of knocks and been exposed to quite challenging conditions with varying temperatures and moisture levels. Easy to modify with additional fans if required (the holes are just right). Putting the case together is easy, though a tight fit - but I'd rather that then it be loose! Highly recommend.”

Helpful Report

Posted 1 year ago

“Great case, looks really sleek. Acts as a natural heatsink too. One issue I had was, it is very difficult to remove the Micro SD card once the case is assembled. Had to resort to (gently) removing with needlenose plyers”

Helpful Report

Posted 1 year ago

“A good case to put together especially if you want to re-case your Pi after already installing heatsinks. Some of the other metal cases act as heatsinks so would have not gone on for my setup. Also leaves space for a fan inside and lets air in nicely! This was a good solution for me. Some say the SD cards are difficult to remove and it is a little awkward however when putting this case together I did become aware some may have put the side part on backward which would make removing SD cards even more difficult! So just make sure you install that side correctly and it’s not so bad.”

Helpful Report

Posted 1 year ago

Author didn't leave any comments.

Helpful Report

Posted 2 years ago

“Good fit between two halves. RPI4b slots in securely and easily. What's not to like.”

Helpful Report

Posted 2 years ago

“It's a good case, but getting the micro D card in and out is a bit tricky. Tweezers needed”

1 Helpful Report

Posted 3 years ago

“Either the port cut-outs in the case were out of specification by a fraction of a millimetre, or my Raspberry Pi 4B was. I had to apply my Dremel to the cut outs to allow the ports to fit into the slots and the Pi to pivot round so that it could be screwed to the single mounting post and the case was fit to go. Otherwise, PiHut delivery and service was as excellent as usual.”

1 Helpful Report

Posted 3 years ago