Camera Case for Raspberry Pi Zero Reviews

4.3 Rating 39 Reviews

Visit Product Page

Email:

contact@thepihut.com

Location:

Mann Enterprises LTDHomefield RoadHaverhill, SuffolkCB9 8QP
Cambridge
CB9 8QP

Visit Product Page

“Instructions warn that fitting camera is a bit awkward but fail to mention that the camera housing is a tight fit in the square opening in the case top, On my first attempt I did not notice slight misalignment with my v1 camera module clone which pulled small cable connector from circuit board. A little filing to remove some plastic and careful test fit sorted problem, fortunately pulled cable was simple push fit but nothing else was holding camera to small circuit board. Still couldn't manage to use supplied 2.5mm nuts to secure camera but had some short standoffs that did the job”

Helpful Report

Posted 3 years ago

“Pretty fiddly to put together, my hands are a bit too big to handle the screws. Also found the screw ends got a bit stripped with screwing, but once it's put together it's a nice little camera case.”

Helpful Report

Posted 3 years ago

“I repurposed this box to install a motion sensor, rather than a camera, it works fine. If it has room for a motion sensor (it was a tight fit), you should have no trouble installing a camera. The box is well built. Some of the screws are a bit fiddly but everything fits together nicely.”

Helpful Report

Posted 4 years ago

“This is a very nice case for your Pi Zero camera, easy to put together, you need a longer cable for the camera as my camera only had a short cable, ordered longer cable at the same time. I have modified my case and Pi Zero for an external antenna.”

1 Helpful Report

Posted 4 years ago

Author didn't leave any comments.

Helpful Report

Posted 4 years ago

“Easy to assemble and get going. Needs a weighty anchor to stop it moving around with the power cable attached. Could do with a battery pack holder to attach to and the power lead going into that to give a more roaming ability with recharge without needing to unplug the Zero inside”

Helpful Report

Posted 4 years ago

“Easy to assemble. Perfect for the Noir camera”

Helpful Report

Posted 4 years ago

“Bit fiddley to put together because of my big fat fingers!! Works fine though, well pleased.”

Helpful Report

Posted 4 years ago