“Given this case is made by the same company that supplied the POE hat that I bought I find it bizarre that there was no room to fit the supplied fan inside.
It’s clear the case absolutely does need cooling, so I’ve kept the official raspberry pi cooler and put a same sized 2 wire fan outside the case with a finger guard. The supplied fan is 4-wire but there is only 4-wire connector for the raspberry pi. My workaround was to use a 2 wire fan of the same size and connected to the 12 V supply on the POE hat.
Although it’s described as a “tall” case, it’s absolutely not suitable for accommodating the POE/NVMe hat sold by the same company along with the required cooling fan, so I’m not actually quite sure what “tall” brings to the party”
“Seems well made, instructions lacking a little, being in the form of a few small pictures with no words. Says it supports hats but not enough room to install the included fan with the PoE+ hat, instructions mention the low profile multi chip cooler should be used but no sign of one, I see it sold elsewhere with this slim blower fan and wonder why not at thepihut.
Some more side airflow for use with hats might be a nice improvement but with the air pressure from a top mounted fan the side grills do pass some undirected airflow. Unit was very hot when taking it out of the case to install something else and the heatsinks were just acting in a passive fashion with no direct airflow once a full sized hat is installed. a slightly larger case with full size HDMI/USB expansion board might have been a better choice for me.
Screws provided with the small open fan were a little long to go through the top cover and the fan frame, leaving 5-10 mm of screw thread sticking out if the provided nuts are pushed into their captive sockets and can't visualise what installation type the additional length is in aid of and it reduces the already tight clearances to any taller components on an installed hat.”
“A well built case and easy to assemble. I used mine to house an RPi5 with active cooler and with a Pimoroni NVMe Duo with two SSDs mounted above the RPi on 25mm standoffs. It worked fine with room to spare. Also, seems to keep pretty cool under load.”