“Neat little sensor. The breakout is rather large because of the two QT connectors, and there's no way I can see to disable the PWR LED for really low power operation. I bought this because I am convinced my BME280 sensors show too high a temperature, but this actually reads consistently a little higher!”
“This is a great little sensor. It is supposed to ge accurate to +/- 0.1°C and 1%RH. But it does seem out of variance with other sensors. Is thus sensour out, or are other sensors similarly out by the same degree?
I'll be calibrating some other sensors soon so I should know then.”
“does what it says on the tin, measures temp and humidity accurately
i replaced a AHT20 with this on my homebrew weather station as the AHT20 suffered in outdoor weather and often stuck at 100% humidity
This SHT45 has a small heater you can use to dry the humidity sensor, there is not much info on the PiHut site about its use, but if you google it , the heater should not be on for more than 10% of the time, and i also founf even on the lowest setting (low for 100ms) you have to delay reading the temp at least 3 minutes or you get an inaccurate reading, just google it and you will find the tech notes about using the heater
so my code for it is on a 3 minute loop, i read the humidity, if above 90% i set the heater and read again to activate the heater, then turn it off again, and read again to reset the heater to of then wait 3 minutes before i make a read to get the real temp and humidity to use on my dashboard”