“Great product if you want to run anything from battery and only need it to run for a short while (interval changeable from 2s - 2hr). I used it in combination with USB breakout boards and a RTC to turn on LEDs on a LEGO set for 1 hr every day.
NOTE: if you connect this to the PI PICO use a diode between the DRV pin and the VSYS on the PICO so you don't back power the TP5110. Also use a resistor eg 4.7k on the DONE pin.”
“I've used this in a Pico-based plant monitoring system where I only wanted a reading every half hour and it cuts power usage right down and makes a small solar panel (with battery) a very viable power source. The timing is a bit tricky to adjust as it's just a resistor dial, so you can't really get it down to the exact minute if you want e.g. every 30 minutes, but you can get close with a bit of trial and error.”
“Finding this piece of equipment was a life saver! Many boards have the possibility to sleep but still use a lot of power in sleep mode compared to this wonderful device! Having the ability to set a "block" to the power and only having this board powered means so many projects are now mega power saving! Just set your project to send a high pulse to the board when done, and it will shut the power off again!
Has been much easier to use than programming an RTC and is a basic timer that cuts the power completely!!”
“Ricevuto in ordine. L'ho provato e sembra funzionare correttamente. Fornisce il tempo di ritardo corrispondente al valore di resistenza inserito e commuta DRV per il tempo previsto di 50 msec. Non ho ancora provato il segnale di input "done" e non ho ancora misurato l'assorbimento di corrente in stand-by che mi aspetto sia bassissimo. In definitiva la mia opinione è al momento positiva.”
“I’m using a few of these to power battery operated ESP-01 temperature sensors. Cut the pcb traces for the led & the trim pot. Fit 100k resistor for a 40 minute time interval and my sensors have been running over 5 weeks on 4 AA rechargeable straight in to the TPL5110 and 3.3v regulator for the ESP.
I had to use the RX pin and a 10k pull down for the done input as I couldn’t get a clean pulse from the 2 io pins.
Simple solution and no need to use deep sleep which the ESP-01 doesn’t have the pins broken out for.
This is a really useful breakout board.”
“This module is a very low power timer which can trigger your other microcontroller device to start and do some tasks. After it finishes your MC can report back to the module that it is time to sleep again. Configurable to run from every 2 seconds and up to 2 hours. Button is for immediate start of your MC. One can also cut traces on the back to turn off LED and consume even less power. Wonderful module, but a little bit pricey.”