“The leds are super bright (which is a good thing) so you will definitely know when the battery is charged super samll pcb. Would love to intergrate this board into my project.”
“Works absolutely flawlessly. Remember to check your wire orientation on the JST connector for your LiPo batts! There is no guarantee which way round they will be and I had to swap the pins on mine. Seen a few comments on Reddit, etc. from people who plugged in without checking and damaged their batts.”
“Works well! The JST plug is 4mm wide (measuring inside the plug), which was actually bigger than the battery I had. Once I replaced the plug on my battery to the correct size everything worked as expected.”
“Really small and super easy to use. Being able to bridge the jumper to allow 500maH is also a nice addition. Richard was really helpful with any technical questions I had and pi-hut is my new go-to place!”
“Great little charger - very useful.
Could use a mosfet load sharing feature to provide battery or usb power output dependent on whether usb is connected.”
