Arched Oak Fireplace Beam 14cm x 12.5cm (5.5” x 5” approx.) / 137cm (4.5ft approx.) Reviews

5 Rating 15 Reviews

About Traditional Beams:

We help home owners interior dreams become a reality through our unique range of handcrafted timber products.

Visit Product Page

Phone:

01287236623

Email:

info@traditionalbeams.com

Location:

Traditional Beams, The Warren Workshop,
Margrove Park, Boosbeck,
Saltburn-by-the-sea
North Yorkshire
TS12 3BZ

Visit Product Page

Luke Dumayne

Verified Reviewer

“Great quality oak with some great rustic features.”

Helpful Report

Posted 7 years ago

Hi Luke, We are thrilled that you are happy with your purchase. Thanks for taking the time to leave us a review.

Posted 7 years ago

Steven Maxwell

Verified Reviewer

“Thanks for supplying lovely arched oak beam, chosen in a danish oil finish it shows off the grain of the wood just right, a few superficial cracks are opening up to further enhance the looks, this oak beam has also given the room an added warmth all by itself. I can highly recomend the product and the company. Thank you "Traditional Beams".”

Helpful Report

Posted 8 years ago

Catriona Brew

Verified Reviewer

Author didn't leave any comments.

Helpful Report

Posted 8 years ago

Michael Haller

Verified Reviewer

“The order arrived on time and well packaged. I realised, quite quickly, that the most important point to take into consideration was the datum point. I made that to be centered about 1 and 1/2 inches above the fire reveal. Most measurements are taken from this point. There are four support pin holes drilled into the rear of the beam and these, on my 6 foot curved beam, are 18 inches apart. They are also 2 and a half inches from the top of the beam. Using a 4' level I marked the hole centres and triple measured the dimensions. I also made sure that the markings were done, making a half inch +. I drilled with a 5mm masonary bit first, to really centre the holes, then went up to the 10mm. (Try and make sure that you drill into the wall at 90 degree and make sure that you have drilled deep enough to accept the pins!) ) Use the level again, across the pins once they are driven in, to make sure that the pins are level. (\you may be able to adjust the position of the pins slightly.Measure 18 inches from the centre of each pin to the adjacent pin; adjustment is possible using a small hammer. When you drive the beam onto the pins be aware that you have a small chamfer on the pin to facilitate fitment. It may seem a daunting task to start with but, providing that your drill measurements are correct, all should be well. Good luck. I would buy from this firm again. Go for it.”

1 Helpful Report

Posted 8 years ago

Zoe Luvaglio

Verified Reviewer

“Fantastic customer service and great quality product. Very pleased.”

2 Helpful Report

Posted 8 years ago

Mark Sherrard

Verified Reviewer

“Fantastic! We took a while pondering the different styles, we saw this one and it's perfect what a difference to the room feels warmer already and the fires not even lit!!”