Fog Lamps MX5 Mk3 Reviews

4.5 Rating 11 Reviews

Genuine Mazda PartSet of genuine Mazda front fog lamps for the Mk3 with standard clear lenses. Imported direct from Mazda Japan.Supplied as a pair, including replacement indicator/lights stork and including all fixings and instructions.Please note: We supply these without the mounting bezels. If you are fitting these to a car that has not had fog lamps fitted before, you NEED to buy the bezels as well.We now stock replacement lamps for these kits should one ever get broken, click here to see! Fits all Mk3 models, 2005>2008

Visit Product Page

Phone:

02392 644588

Email:

sales@mx5parts.co.uk

Location:

1 Orion Court, 5 Rodney Road,,
Portsmouth
PO4 8SZ

Visit Product Page

Matthew Wilson

Verified Reviewer

“Picked these up personally .Great service .Fitting really simple all done in an hour .I used a trolley jack to lift front end .Popped the front wheel arch retainers and in went the lamps .”

Helpful Report

Posted 14 years ago

Neil Rossiter

Verified Reviewer

“Looks great easy to fit, silver bezals match the silver in the headlights. As other reviews state turn the wheels to full lock, I did it with the wheel pointing out on the side I was working on , dident even raise the car remove the wheel arch holding screws (bottom 5, 1/4 turn and they pop out. Peel the wheelarch cover open just enough to get your hand in. Pop the fog lamp blank off. Carfully slide in the fog lamp attached to the bezal between the wheelarch liner and the wing pop into place secure with the supplied screws connect the plug that is taped back with in my case blue insulating tape. Repeat other side. Fiting the new stalk is easy , unscrew the three screws on the botton of the stearing wheel binical, remove the top half of the binical. Remove the bottom half, REMEMBER TO TAKE CARE WITH THE KEY ILUMINATION LED. Unscrew the two small screws holding in the stalk pull out towards the passenger door MIND THE DASH and unplug,fit the new supplied stalk refit the binical,and switch on!!I alinged the lamp farly newtral in the bezal same gap all round beteen the lanp and the bezal and it is aligned just fine. Silver bezal looks great on my Copper red rag top.”

Helpful Report

Posted 15 years ago

Adrian Noble

Verified Reviewer

“Great purchase, cheaper than the Mazda Dealer, despite thier 24% reduction were unable to Match the MX5 Parts price.Straightforward fit, no need to isolate the battery or take off the bumber, just put one wheel up on the Kerb, turn the wheel outwards, if you are right handed work on the left side of the car first. remove the mudguard securing clips by using a phillips head screwdriver to turn the clips anticlockwise and pull them out to reuse later on. you will see the fog lamp cover, remove by easing the three clips outwards and the cover will fall inwards.Assemble to foglamp with the bezel, attach the wiring that is already in place secured with a peice of tape, screw in the assembled lamp and bezel using two screws one on the top and one inward facing. Repeat the other side. The columb stalk is removed by removing the phillips head screws under the steering rack x 3. there is one securing screw- remove. put in the new stalk and screw in place.The front fog comes on with the side light and is illuminated yellow, then advance the switch further to engage the front and rear fog lamps illuminated red. take your time you dont need to be Einstein to fit these.”

Helpful Report

Posted 16 years ago